AlveyTech 11" x 7.10-5 PVC Plastic Tire Sleeve - Replacement for Drift Trikes, Go-Karts, Drifting Scooter, Drifter Wheel Hub Accessories, Smooth Tires Shroud for Adult/Kids Trikes, DIY Install, 2-Pack

If you want to turn your go-kart into a drifter, our set of two 11x7.10-5 PVC plastic tire sleeves for drift trikes and go-karts will make your slick tires even slicker and slippier. Made from hard PVC, the replacement plastic sleeves were designed to limit the amount of rear tire traction and provide your ride with a faster drift effect. Unlike some drift sleeves that are slick both inside and out, this version sports a series of radial ridges on the inside face of the sleeve to provide a superior grip on the tire's rubber. This prevents the sleeve from accidentally slipping or spinning off if the tire pressure is too low. Note: These hard PVC drift sleeves are made to fit tightly onto the tire. In order to mount easily, you should let some of the air out, then lubricate the tire with soap suds before pressing the sleeve onto the rubber. The pressing may be easier with a wood or rubber mallet. When the sleeve is in its correct position, just refill the tire with the correct air pressure. In addition, the PVC sleeve may adhere to the rubber tire better by using several strips of self-adhesive grip tape (such as used on skateboard decks) on the sleeve's inner face. Specifications Outer diameter: 11-3/8" Inner diameter: 10-1/2" Width: 6"

• Set of two sleeves.
• 11x7.10-5 is common to many go-kart models.
• Hard PVC tire sleeve with inside ridges for a better grip on the rubber tire.
• If you want to turn your go-kart into a drifter, our set of two 11x7.10-5 PVC plastic tire sleeves for drift trikes and go-karts will make your slick tires even slicker and slippier.
• These hard PVC drift sleeves are made to fit tightly onto the tire. In order to mount easily, you should let some of the air out, then lubricate the tire with soap suds before pressing the sleeve onto the rubber. The pressing may be easier with a wood or rubber mallet. When the sleeve is in its correct position, just refill the tire with the correct air pressure.